Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Commands
1-15
In case the device malfunctions after being powered on, if you find some configurations
are not validated or incorrect, you may use this command to identify the problem.
If you do not use the configuration file when the device starts up, meaning the displayed
startup configuration file is NULL after you execute the display startup command, no
information is displayed when you execute the display saved-configuration
command; if you have saved the configuration file after the device starts up, the
information last saved in the configuration file is displayed.
Related commands: save, reset saved-configuration, display
current-configuration in System Maintaining and Debugging Commands.
Examples
# Display the configuration file saved in the storage device.
<Sysname> display saved-configuration
#
version 5.00, 0000
#
sysname Mydevice
#
local-user abc password simple abc
#
tcp window 8
#
interface Aux1/0
link-protocol ppp
#
interface Ethernet1/1
#
interface Ethernet1/2
#
interface Ethernet1/3
ip address 10.110.101.17 255.255.255.0
#
interface NULL0
#
ospf 1
#
ip route-static 10.12.0.0 255.255.0.0 Ethernet 1/0
#
user-interface con 0
user-interface aux 0
user-interface vty 0 4
authentication-mode none
To Next Page
Loading...
Need help?
General
