H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-1
Chapter 2 IPv6 RIPng Configuration Commands
 Note:
z Throughout this chapter, the term “router” refers to a Layer 3 switch running routing
protocols.
z At present, the LSQ1GP12EA boards in the S7500E series do not support IPv6.
2.1 RIPng Configuration Commands
2.1.1 checkzero
Syntax
checkzero
undo checkzero
View
RIPng view
Parameters
None
Description
Use the checkzero command to enable the zero field check on RIPng packets.
Use the undo checkzero command to disable the zero field check.
The zero field check is enabled by default.
Some fields in RIPng packet headers must be zero. These fields are called zero fields.
You can enable the zero field check on RIPng packet headers. If any such field contains
a non-zero value, the RIPng packet will be discarded.
Examples
# Disable the zero field check on RIPng packet headers of RIPng 100.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] undo checkzero

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English