Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches Chapter 2 RMON Configuration Commands
2-3
Examples
# Display the configuration of RMON event table.
<Sysname> display rmon event
Event table 1 owned by user1 is VALID.
Description: null.
Will cause log-trap when triggered, last triggered at 0days 00h:02m:27s.
Table 2-2 Description on the fields of the display rmon event command
Field Description
Event table Event entry number
owned by Owner of the entry
VALID
Status of the entry identified by the index (VALID
means the entry is valid, and UNDERCREATION
means invalid. You can use the display rmon
command to view the invalid entry and with the
display current-configuration and display this
commands you cannot view the corresponding
rmon commands.)
Description Description for the event
cause log-trap when triggered The event will trigger logging and trapping.
last triggered at Last time the event was triggered
2.1.3 display rmon eventlog
Syntax
display rmon eventlog [ entry-number ]
View
Any view
Parameters
entry-number: Index of an event entry, in the range 1 to 65535. If no entry number is
specified, the log information for all event entries is displayed.
Description
Use the display rmon eventlog command to display log information for the specified
or all event entries.
If you use the rmon event command to specify that the action of an entry includes
logging, then when this event is triggered, the event log is retained in the RMON log list.
You can use the display rmon eventlog command to display detailed log information
To Next Page
Loading...
Need help?
General
