H3C S7500E Series

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-12
1.1.12 port-group aggregation
Syntax
port-group aggregation agg-id
View
System view
Parameters
agg-id: Aggregation port group ID, same as the ID of its corresponding link aggregation
group.
Description
Use the port-group aggregation command to enter aggregation port group view.
Instead of being created administratively, an aggregation port group is created
automatically upon creation of a link aggregation group and assigned the ID of the link
aggregation group. In aggregation port group view, you can configure aggregation
related settings such as STP, VLAN, QoS, GVRP, Q-in-Q, BPDU tunnel, and MAC
address learning, but cannot add or remove member ports.
Examples
# Enter aggregation port group view.
<Sysname> system-view
[Sysname] port-group aggregation 10
[Sysname-port-group-aggregation-10]
1.1.13 reset lacp statistics
Syntax
reset lacp statistics [ interface interface-type interface-number [ to interface-type
interface-number ] ]
View
User view
Parameters
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies an interface range or an interface if the to keyword and the second interface
are not specified.