H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-7
Use the undo c-bsr holdtime command to restore the system default.
By default, the bootstrap timeout value is determined by this formula: Bootstrap timeout
= Bootstrap interval × 2 + 10.
 Note:
The default bootstrap interval is 60 seconds, so the default bootstrap timeout = 60 × 2 +
10 = 130 (seconds).
Related commands: c-bsr, c-bsr interval.
Examples
# Set the bootstrap timeout time to 150 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-bsr holdtime 150
4.1.9 c-bsr interval
Syntax
c-bsr interval interval
undo c-bsr interval
View
PIM view
Parameters
interval: Bootstrap interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the c-bsr interval command to configure the bootstrap interval, namely the
interval at which the BSR sends bootstrap messages.
Use the undo c-bsr interval command to restore the system default.
By default, the bootstrap interval value is determined by this formula: Bootstrap interval
= (Bootstrap timeout – 10) ÷ 2.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English