To Next Page

To Previous Page

Command Manual – VLAN

H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands

1-20

Caution:

Due to the close relationship between IPv4 and ARP, it is recommended to bind the two

protocols to the same VLAN and associate the binding to related ports to guarantee

normal communication.

Configure ARP protocol template for VLAN3 (ARP code is 0x0806) to make the VLAN

transmit ARP packets.

z To use Ethernet encapsulation, use the command:

[Sysname-vlan3] protocol-vlan mode ethernetii etype 0806

z To use 802.3 encapsulation, use the command:

[Sysname-vlan3] protocol-vlan mode snap etype 0806

1.4 IP-Subnet-Based VLAN Configuration Commands

1.4.1 display ip-subnet-vlan interface

Syntax

display ip-subnet-vlan interface { interface-type interface number1 [ to interface-type

interface-number2 | all }

View

Any view

Parameters

interface-type interface-number1: Specifies a port by its type and number.

Interface-type interface-number1 to Interface-type interface-number2: Specifies

multiple ports.

all: Displays the IP-subnet-based VLAN information about all the ports with

IP-subnet-based VLAN configured.

Description

Use the display ip-subnet-vlan interface command to display the IP-subnet-based

VLAN information and IP subnet ID on a specified port.

Examples

# Display the IP-subnet-based VLAN information and IP subnet index on Ethernet

2/0/1.

<Sysname> display ip-subnet-vlan interface ethernet 2/0/1

Interface: Ethernet2/0/1

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series