H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-47
Parameters
None
Description
Use the register-whole-checksum command to configure the router to calculate the
checksum based on the entire register message.
Use the undo register-whole-checksum command to restore the default
configuration.
By default, the checksum is calculated based on the header in the register message.
Related commands: register-policy, register-suppression-timeout.
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] register-whole-checksum
4.1.54 reset pim control-message counters
Syntax
reset pim control-message counters [ interface interface-type interface-number ]
View
User view
Parameters
interface interface-type interface-number: Specifies to reset the PIM control message
counter on a particular interface. If no interface is specified, this command will clear the
statistics information of PIM control messages on all interfaces.
Description
Use the reset pim control-message counters command to reset PIM control
message counters.
Examples
# Reset PIM control message counters on all interfaces.
<Sysname> reset pim control-message counters