H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 1 IGMP Snooping Configuration Commands
1-23
1.1.25 igmp-snooping static-router-port
Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Ethernet interface view, port group view
Parameters
vlan vlan-id: Specifies a VLAN in which one or more static router ports are to be
configured, where vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping static-router-port command to enable the static router port
function.
Use the undo igmp-snooping static-router-port command to disable the static router
port function.
By default, the static router port function is not enabled.
Note that:
z This command works on IGMP Snooping–enabled VLANs and VLANs with IGMP
enabled on the corresponding VLAN interfaces.
z If configured in Ethernet interface view, this feature takes effect on the port only if
the port belongs to the specified VLAN.
z If configured in port group view, this feature takes effect only on those ports in this
port group that belong to the specified VLAN.
Examples
# Enable the static router port function on Ethernet 2/0/1, which belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping static-router-port vlan 2
1.1.26 igmp-snooping version
Syntax
igmp-snooping version version-number
undo igmp-snooping version

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English