H3C S7500E Series

Command Manual – DHCP
H3C S7500E Series Ethernet Switches
Chapter 2 DHCP Relay Agent Configuration
Commands
2-2
Examples
# Enable DHCP.
<Sysname> system-view
[Sysname] dhcp enable
2.1.2 dhcp relay address-check
Syntax
dhcp relay address-check { disable | enable }
View
Interface view
Parameters
disable: Disables IP address match checking on the relay agent.
enable: Enables IP address match checking on the relay agent.
Description
Use the dhcp relay address-check enable command to enable IP address match
check on the relay agent.
Use the dhcp relay address-check disable command to disable IP address match
check on the relay agent.
By default, the function is disabled.
Examples
# Enable IP address match checking on the DHCP relay agent.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay address-check enable
2.1.3 dhcp relay information enable
Syntax
dhcp relay information enable
undo dhcp relay information enable
View
Interface view