H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-5
Field Description
Suppress time RIP suppress interval
Garbage-collect time RIP garbage collection interval
TRIP retransmit time
TRIP retransmit interval for sending
update requests and responses.
TRIP response packets retransmit count
Maximum retransmit times for update
requests and responses
Silent interfaces
Number of silent interfaces, which do not
periodically send updates
Default routes
Indicates whether a default route is sent
to RIP neighbors
Verify-source
Indicates whether the source IP address
is checked on the received RIP routing
updates
Networks Networks enabled with RIP
Configured peers Configured neighbors
Triggered updates sent Number of sent triggered updates
Number of routes changes
Number of changed routes in the
database
Number of replies to queries Number of RIP responses
2.1.5 display rip database
Syntax
display rip process-id database
View
Any view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the display rip database command to display the active routes in the RIP
database, which are sent in normal RIP routing updates.
Examples
# Display the active routes in the database of RIP process 100.
<Sysname> display rip 100 database

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English