Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-16
Parameters
none: None authorization, which means the user is trusted completely. Here, the user
is assigned with the default privilege.
radius-scheme radius-scheme-name: Specifies a RADIUS scheme by its name, which
is a string of 1 to 32 characters.
Description
Use the authorization portal command to specify the authorization scheme for portal
users.
Use the undo authorization portal command to restore the default.
By default, the default authorization scheme is used for portal users.
Note that the RADIUS scheme specified for the current ISP domain must have been
configured.
Related commands: authorization default, radius scheme.
Examples
# In the default ISP domain system, specify the authorization scheme for portal users
to RADIUS scheme, with the name rd.
<Sysname> system-view
[Sysname] domain system
[Sysname-isp-system] authorization portal radius-scheme rd
1.1.17 cut connection
Syntax
cut connection { access-type { dot1x | mac-authentication | portal } | all | domain
isp-name | interface interface-type interface-number | ip ip-address | mac
mac-address | ucibindex ucib-index | user-name user-name | vlan vlan-id } [ slot
slot-number ]
View
System view
Parameters
access-type: Specifies user connections of an access mode.
z dot1x: Specifies 802.1x authentication user connections.
z mac-authentication: Specifies MAC authentication user connections.
z portal: Specifies portal authentication user connections.
all: Specifies all user connections.
To Next Page
Loading...
Need help?
General
