H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-43
View
Interface view
Parameters
interval: Hello interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the pim timer hello command to configure on the current interface the interval at
which hello messages are sent.
Use the undo pim timer hello command to restore the system default.
By default, hello messages are sent at the interval of 30 seconds.
Related commands: timer hello.
Examples
# Set the hello interval to 40 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim timer hello 40
4.1.48 pim timer join-prune
Syntax
pim timer join-prune interval
undo pim timer join-prune
View
Interface view
Parameters
interval: Join/prune interval in seconds, with an effective range of 1 to 2,147,483,647.
Description
Use the pim timer join-prune command to configure on the current interface the
interval at which join/prune messages are sent.
Use the undo pim timer join-prune command to restore the system default.
By default, the join/prune interval is 60 seconds.
Related commands: timer join-prune.
Examples
# Set the join/prune interval to 80 seconds on VLAN-interface 100.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English