Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IPv6 IS-IS Configuration Commands
4-8
allow-ibgp: Allows the redistribution of IBGP routes. This keyword is optional when the
protocol is bgp4+.
Description
Use the ipv6 import-route command to enable IPv6 IS-IS to redistribute routes from
another routing protocol.
Use the undo ipv6 import-route command to disable route redistribution.
Route redistribution is disabled by default.
If no level is specified, the routes are imported to Level-2 routing table by default.
IPv6 IS-IS considers redistributed routes as routes to destinations outside the local
routing domain.
You can specify a cost and a level for redistributed routes.
Caution:
Using the import-route bgp4+ allow-ibgp command will redistribute both EBGP and
IBGP routes. The redistributed IBGP routes may cause routing loops. Therefore, be
cautious with this command.
Examples
# Configure IPv6–IS-IS to redistribute static routes and sets the cost 15 for them.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1]ipv6 import-route static cost 15
4.1.7 ipv6 import-route isisv6 level-2 into level-1
Syntax
ipv6 import-route isisv6 level-2 into level-1 [ filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name | route-policy route-policy-name } | tag tag ]*
undo ipv6 import-route isisv6 level-2 into level-1
View
IS-IS view
To Next Page
Loading...
Need help?
General
