Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-3
Table 1-1 Description on the fields of the display link-aggregation interface
command
Field Description
Flags
One-octet LACP state flags field. From the least to the
most significant bit, they are represented by A through H
as follows:
z A indicates whether LACP is enabled, 1 for enabled
and 0 for disabled.
z B indicates the timeout control value, 1 for short
timeout, and 0 for long timeout.
z C indicates whether the sending system considers this
link to be aggregatable, 1 for true, and 0 for false.
z D indicates whether the sending system considers that
this link is synchronized, 1 for true, and 0 for false.
z E indicates whether the sending end considers that
collection of incoming frames is enabled on the link, 1
for true and 0 for false.
z F indicates whether the sending system considers that
distribution of outgoing frames is enabled on the link, 1
for true and 0 for false.
z G indicates whether the receive state machine of the
sending system is using default operational partner
information, 1 for true and 0 for false.
z H indicates whether the receive state machine of the
sending system is in the expired state, 1 for true and 0
for false.
If a flag bit is set to 1, the corresponding English letter that
otherwise is not output displays.
Selected AggID
ID of the link aggregation group of which this port is a
member
Local:
Port-Priority, Oper key,
Flag
Local port LACP priority, operational key, LACP state flag
Remote:
System ID, Port
Number, Port-Priority,
Oper-key, Flag
Remote system ID, port number, port LACP priority,
operational key, and LACP state flag
Received LACP
Packets, Illegal, Sent
LACP Packets
Statistics about received, invalid, and sent LACP packets
1.1.3 display link-aggregation service-type
Syntax
display link-aggregation service-type [ agg-id ]
To Next Page
Loading...
Need help?
General
