H3C S7500E Series

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands
1-15
[Sysname-Ethernet2/0/1] port trunk pvid vlan 100
1.3 Protocol-Based VLAN Configuration Commands
1.3.1 display protocol-vlan interface
Syntax
display protocol-vlan interface { interface-type interface-number1 [ to interface-type
interface-number2 ] | all }
View
Any view
Parameters
interface-type interface-number1: Specifies an port by its type and number.
interface-type interface-number1 to interface-type interface-number2: Specifies an port
range.
all: Displays protocol information and protocol indexes of all ports.
Description
Use the display protocol-vlan interface command to display protocol based VLAN
information on the specified port(s).
Examples
# Display protocol based VLAN information on Ethernet 2/0/1.
[Sysname] display protocol-vlan interface ethernet 2/0/1
Interface: Ethernet2/0/1
VLAN ID Protocol Index Protocol Type
======================================================
2 0 ipv4
2 3 ipx ethernetii
Table 1-3 Description on the fields of the display protocol-vlan interface command
Field Description
Interface Port of which you want to view the information
VLAN ID VLAN ID
Protocol Index Protocol Index
Protocol Type Protocol Type