H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches Chapter 1 IPv6 Basics Configuration Commands
1-22
Table 1-13 Description on fields of the display udp ipv6 statistics command
Field Description
Total Total number of received/sent packets
checksum error
Total number of packets with a
checksum error
shorter than header
Total number of IPv6 UDP packets
whose total length is less than specified
by the packet header
data length larger than packet
Total number of packets whose data
length exceeds that specified by the
packet header
unicast(no socket on port)
Total number of unicast packets without
any socket received on a port
broadcast/multicast(no socket on port)
Total number of broadcast/multicast
packets without any socket received on
a port
not delivered, input socket full
Number of packets not handled because
of the receive buffer being full
input packet missing pcb cache
Number of packets failing to match the
PCB cache
1.1.14 dns server ipv6
Syntax
dns server ipv6 ipv6-address [ interface-type interface-number ]
undo dns server ipv6 ipv6-address [ interface-type interface-number ]
View
System view
Parameters
ipv6-address: IPv6 address of a DNS server.
interface-type interface-number: Specifies an interface. When the IPv6 address of the
DNS server is a link-local address, this argument must be specified.
Description
Use the dns server ipv6 command to configure an IPv6 address for a DNS server.
Use the undo dns server ipv6 command to remove the configured DNS server.
By default, no DNS server is configured.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English