H3C S7500E Series

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-69
Note that:
z The IP addresses of the primary and secondary authorization servers cannot be
the same. Otherwise, the configuration fails.
z The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
z If you configure the command for more than one time, the last configuration takes
effect.
z You can remove an authorization server only when no active TCP connection for
sending authorization packets is using it.
Related commands: display hwtacacs.
Examples
# Configure the primary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49
1.3.11 reset hwtacacs statistics
Syntax
reset hwtacacs statistics { accounting | all | authentication | authorization } [ slot
slot-number ]
View
User view
Parameters
accounting: Clears HWTACACS accounting statistics.
all: Clears all HWTACACS statistics.
authentication: Clears HWTACACS authentication statistics.
authorization: Clears HWTACACS authorization statistics.
slot slot-number: Clears HWTACACS statistics on the interface card in the specified
slot.
Description
Use the reset hwtacacs statistics command to clear HWTACACS statistics.
Related commands: display hwtacacs.
Examples
# Clear all HWTACACS statistics.