H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-45
[Sysname-ospf-100] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf authentication-mode md5 15 cipher abc
# Configure the network 131.119.0.0/16 in Area 1 to support simple authentication, and
set for the interface the authentication password to abc, and password type to cipher.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Sysname-ospf-100-area-0.0.0.1] authentication-mode simple
[Sysname-ospf-100-area-0.0.0.1] quit
[Sysname-ospf-100] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf authentication-mode simple cipher abc
3.1.40 ospf cost
Syntax
ospf cost value
undo ospf cost
View
Interface view
Parameters
value: OSPF cost, in the range 1 to 65535.
Description
Use the ospf cost command to set an OSPF cost for the interface.
Use the undo ospf cost command to restore the default OSPF cost for the interface.
By default, an OSPF interface calculates its cost with the formula: interface default
OSPF cost=100 Mbps/interface bandwidth(Mbps). Default OSPF costs of some
interfaces are:
z 1785 for the 56kbps serial interface
z 1562 for the 64kbps serial interface
z 48 for the E1 (2.048Mbps) interface
z 1 for the Ethernet interface
You can use the ospf cost command to set an OSPF cost for an interface manually.
This configuration is not supported on the NULL interface.