H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-15
Total 0 0 0 0 0 0 1
Table 3-9 Description on the fields of the display ospfv3 peer statistic command
Field Description
Area ID Area ID
Down
In this state, neighbor initial state, the router has not received any
information from a neighboring router for a period of time.
Init
In this state, the device received a Hello packet from the neighbor
but the packet contains no Router ID of the neighbor. Mutual
communication is not setup.
2-Way
Indicates mutual communication between the router and its
neighbor is available. DR/BDR election is finished under this state
(or higher).
ExStar
In this state, the router decides on the initial DD sequence
number and master/slave relationship of the two parties.
Exchange In this state, the router exchanges DD packets with the neighbor.
Loading
In this state, the router sends LSRs to request the neighbor for
needed LSAs.
Full
Indicates LSDB synchronization has been accomplished between
neighbors.
Total Total number of neighbors under the same state
3.1.12 display ospfv3 request-list
Syntax
display ospfv3 [ process-id ] request-list [ { external | inter-prefix | inter-router |
intra-prefix | link | network | router } [ link-state-id ] [ originate-router ip-address ] |
statistics ]
View
Any view
Parameters
process-id: OSPFv3 process ID, in the range 1 to 65535.
external: Displays the AS-external LSA information of the OSPFv3 link state request
list.
inter-prefix: Displays the Inter-area-prefix LSA information of the OSPFv3 link state
request list.
inter-router: Displays the Inter-area-router LSA information of the OSPFv3 link state
request list.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English