H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-9
# Describe the OSPF area0 as bone area.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 0
[Sysname-ospf-100-area-0.0.0.0] description bone area
3.1.10 display ospf abr-asbr
Syntax
display ospf [ process-id ] abr-asbr
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf abr-asbr command to display ABR/ASBR information.
If no process is specified, the ABR/ASBR information of all OSPF processes is
displayed.
If you use this command on routers in a stub area, no ASBR information is displayed.
Examples
# Display ABR/ASBR information.
<Sysname> display ospf abr-asbr
OSPF Process 1 with Router ID 192.168.1.2
Routing Table to ABR and ASBR
Type Destination Area Cost Nexthop RtType
Inter 3.3.3.3 0.0.0.0 3124 10.1.1.2 ASBR
Intra 2.2.2.2 0.0.0.0 1562 10.1.1.2 ABR
Table 3-1 Description on the fields of the display ospf abr-asbr command
Field Description
Type Intra-area router or Inter-area router
Destination Router ID of an ABR/ASBR
Area ID of the area of the next hop
Cost Cost from the router to the ABR/ASBR