Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 2 HA Configuration Commands
2-1
Chapter 2 HA Configuration Commands
2.1 HA Configuration Commands
2.1.1 display switchover state
Syntax
display switchover state [ slot-id ]
View
Any view
Parameters
slot-id: Slot ID of the active main board (AMB) or standby main board (SMB).
Description
Use the display switchover state command to display the switchover state.
The switchover state of the corresponding card will be displayed if slot number is
specified. The switchover state of the AMB will be displayed if no slot number is
specified.
Examples
# Display the switchover state on the AMB.
<Sysname> display switchover state
HA FSM State(master): Slave is absent.
Table 2-1 Description on the fields of the display switchover state command
Field Description
Slave is absent The SMB is not in the slot.
Waiting batch backup request from slave
Waiting for the backup requests from the
SMB
Batch backup Backup state
Realtime and routine backup to slave Real-time or routine backup state