H3C S7500E Series Command Manual

Command Manual – QinQ-BPDU Tunneling
H3C S7500E Series Ethernet Switches Chapter 1 QinQ Configuration Commands
1-5
Description
Use the qinq ethernet-type customer-tag command to configure the TPID value of
the customer network VLAN tags.
Use the undo qinq ethernet-type customer-tag command to restore the system
default.
By default, the TPID value of the customer network VLAN tags is 0x8100.
Examples
# Set the TPID value of the customer network VLAN tags to 0x9100.
<Sysname> system-view
[Sysname] qinq ethernet-type customer-tag 9100
1.1.6 qinq ethernet-type service-tag
Syntax
qinq ethernet-type service-tag hex-value
undo qinq ethernet-type service-tag
View
Ethernet port view, port group view
Parameters
hex-value: Hexadecimal protocol type ID, in the range of 0x0001 to 0xFFFF except the
protocol type values listed in
Table 1-1.
Description
Use the qinq ethernet-type service-tag command to configure the TPID value of the
service provider network VLAN tags.
Use the undo qinq ethernet-type service-tag command to restore the default.
By default, the TPID value of the service provider network VLAN tags is 0x8100.
Examples
# Set the TPID value of the service provider network VLAN tags to 0x9100 for Ethernet
2/0/1.
<Sysname> system-view
[Sysname] interface ethernet2/0/1
[Sysname-Ethernet2/0/1] qinq ethernet-type service-tag 9100

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English