Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-10
View
Routing policy view
Parameters
value: Tag value, in the range 0 to 4294967295.
Description
Use the apply tag command to set a specified tag value for RIP, OSPF or IS-IS routing
information.
Use the undo apply tag command to remove the clause configuration.
No routing tag is set for RIP, OSPF or IS-IS routing information by default.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip-address next-hop,
apply local-preference, apply cost, apply origin.
Examples
# Create routing policy policy1 with node 10, matching mode as permit. If a route
matches OSPF external route type 1, set the tag of the route to 100.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match route-type external-type1
[Sysname-route-policy] apply tag 100
6.1.13 display ip as-path
Syntax
display ip as-path [ as-path-number ]
View
Any view
Parameters
as-path-number: AS path ACL number, in the range of 1 to 256.
Description
Use the display ip as-path command to display BGP AS path ACL information.
Information about all BGP AS path lists will be displayed if no as-path-number is
specified.
Related commands: ip as-path, if-match as-path, apply as-path.
To Next Page
Loading...
Need help?
General
