To Next Page

To Previous Page

Command Manual – ACL

H3C S7500E Series Ethernet Switches Chapter 1 ACL Configuration Commands

1-22

By default, rule numbering step is five.

Examples

# Set the rule numbering step to 2 for ACL 2000.

<Sysname> system-view

[Sysname] acl number 2000

[Sysname-acl-basic-2000] step 2

# Set the rule numbering step to 2 for ACL 3000.

<Sysname> system-view

[Sysname] acl number 3000

[Sysname-acl-adv-3000] step 2

# Set the rule numbering step to 2 for ACL 4000.

<Sysname> system-view

[Sysname] acl number 4000

[Sysname-acl-ethernetframe-4000] step 2

1.3 IPv6 ACL Configuration Commands

1.3.1 acl ipv6

Syntax

acl ipv6 number acl6-number [ name acl6-name ] [ match-order { auto | config } ]

undo acl ipv6 { all | name acl6-name | number acl6-number }

View

System view

Parameters

number: Defines a numbered IPv6 ACL.

acl6-number: IPv6 ACL number, which must be in the following ranges:

z 2000 to 2999 for basic IPv6 ACLs

z 3000 to 3999 for advanced IPv6 ACLs

name acl6-name: Specifies the name of the ACL, which is a case insensitive string of 1

to 32 characters. It must start with an English letter and cannot be the English word of

all to avoid confusion.

match-order: Sets the order in which ACL rules are matched.

z auto: Performs depth-first match. For how depth-first match works, refer to the

“IPv6 ACL Match Order” section in accompanied ACL Configuration.

z config: Performs matching against rules in the order in which they are configured.

all: All IPv6 ACLs.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series