To Next Page

To Previous Page

Command Manual – IP Routing Overview

H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands

1-15

Static Routing table Status : < Inactive>

Summary Count : 1

Destination/Mask Proto Pre Cost NextHop Interface

1.2.3.0/24 Static 60 0 1.2.4.5 Vlan10

For detailed description of the above output, see Table 1-4.

1.1.8 display ip routing-table statistics

Syntax

display ip routing-table statistics

View

Any view

Parameters

None

Description

Use the display ip routing-table statistics command to display statistics about the

public network routing table.

Examples

# Display statistics about the routes in the routing table.

<Sysname> display ip routing-table statistics

Proto route active added deleted freed

DIRECT 24 4 25 1 0

STATIC 4 1 4 0 0

RIP 0 0 0 0 0

OSPF 0 0 0 0 0

IS-IS 0 0 0 0 0

BGP 0 0 0 0 0

Total 28 5 29 1 0

Table 1-6 Description on the fields of display ip routing-table statistics

Field Description

Proto

Origin of the routes. Possible values include O_ASE for OSPF_ASE

routes, O_NSSA for OSPF NSSA, and AGGRE for aggregated routes.

route

Number of routes from the origin

active Number of active routes from the origin

added

Number of routes added into the routing table since the router starts up

or the last routing table reset operation

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series