H3C S7500E Series

Command Manual – IP Addressing and Performance
H3C S7500E Series Ethernet Switches
Chapter 1 IP Addressing Configuration
Commands
1-1
Chapter 1 IP Addressing Configuration
Commands
1.1 IP Addressing Configuration Commands
1.1.1 display ip interface
Syntax
display ip interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display ip interface command to display information about a specified or all
Layer 3 interfaces.
Examples
# Display information about interface VLAN-interface 1.
<Sysname> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
ip fast-forwarding incoming packets state is Disable
ip fast-forwarding outgoing packets state is Disable
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
ARP packet input number: 0
Request packet: 0
Reply packet: 0
Unknown packet: 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0