H3C S7500E Series Command Manual

Command Manual – IP Addressing and Performance
H3C S7500E Series Ethernet Switches
Chapter 1 IP Addressing Configuration
Commands
1-2
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
DHCP packet deal mode: global
Table 1-1 Description on fields of the display ip interface command
Field Description
current state Current physical state of an interface
Line protocol current state Current state of the network layer protocol
Internet Address
IP address of an interface followed by:
z Primary: Identifies a primary IP address, or
z Sub: Identifies a secondary IP address.
Broadcast address
Broadcast address of the subnet attached to an
interface
The Maximum Transmit Unit Maximum transmission units on an interface
input packets : 0, bytes : 0,
multicasts : 0
output packets : 0, bytes : 0,
multicasts : 0
Unicast packets, bytes, and multicast packets
received on an interface
Unicast packets, bytes, and multicast packets
sent on an interface
ARP packet input number: 0
Request packet: 0
Reply packet: 0
Unknown packet: 0
Total number of ARP packets received on an
interface, including
z ARP request packets
z ARP reply packets
z Unknown packets
TTL invalid packet number
Number of TTL-invalid packets received on an
interface

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English