H3C S7500E Series

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GARP/GVRP Configuration Commands
4-6
Description
Use the display gvrp local-vlan interface command to display the local VLAN
information maintained by GVRP on a port.
Examples
# Display the local VLAN information maintained by GVRP on Ethernet 2/0/1.
<Sysname> display gvrp local-vlan interface ethernet 2/0/1
Following VLANs exist in GVRP local database:
1(default),2-500
// The information above shows that GVRP maintains the information about VLAN 1,
VLAN 2 through VLAN 500, which Ethernet 2/0/1 belongs to.
4.2.2 display gvrp state
Syntax
display gvrp state interface interface-type interface-number vlan vlan-id
View
Any view
Parameters
interface interface-type interface-number: Specifies an interface by its type and
number.
vlan vlan-id: Specifies a VLAN ID, in the range 1 to 4094.
Description
Use the display gvrp state command to display the current GVRP state.
Examples
# Display the GVRP state of VLAN 1, which Ethernet 2/0/1 belongs to.
<Sysname> display gvrp state interface ethernet 2/0/1 vlan 1
GVRP state of VLAN 1 on port Ethernet2/0/1
Applicant state machine : VP
Registrar state machine : MTR
4.2.3 display gvrp statistics
Syntax
display gvrp statistics [ interface interface-list ]