H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 2 IPv6 RIPng Configuration
Commands
2-6
Table 2-3 Description on the fields of the display ripng interface command
Field Description
Interface-name Name of an interface running RIPng.
Link Local Address Link-local address of an interface running RIPng
Split-horizon
Indicates whether the split horizon function is enabled (on:
Enabled off: Disabled).
Poison-reverse
Indicates whether the poison reverse function is enabled
(on: Enabled off: Disabled).
MetricIn/MetricOut Additional metric to incoming and outgoing routes
Default route
z Only/Originate: Only means that the interface
advertises only default route. Originate means that the
default route and other RIPng routes are advertised.
z Off, indicates that no default route is advertised or the
garbage-collect time expires after the default route
advertisement was disabled.
z In garbage-collect status: With default route
advertisement disabled, the interface advertises the
default route with metric 16 during the garbage-collect
time.
2.1.6 display ripng route
Syntax
display ripng process-id route
View
Any view
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use the display ripng route command to display all RIPng routes and timers
associated to each route of a RIPng process.
Examples
# Display the routing information of RIPng process 100.
<Sysname> display ripng 100 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English