Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-1
Chapter 1 802.1x Configuration Commands
1.1 802.1x Configuration Commands
1.1.1 display dot1x
Syntax
display dot1x [ sessions | statistics ] [ interface interface-list ]
View
Any view
Parameters
sessions: Displays 802.1x session information.
statistics: Displays 802.1x statistics.
interface interface-list: Specifies an Ethernet port list, which can contain multiple
Ethernet ports. The interface-list argument is in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] } & <1-10>,
where interface-type represents the port type, interface-number represents the port
number, and & <1-10> means that you can provide up to 10 port indexes/port index lists
for this argument. The start port number must be smaller than the end number and the
two ports must of the same type.
Description
Use the display dot1x command to display information about 802.1x, including
session information, statistics, or configuration.
With both the sessions keyword and the statistics keyword not provided, this
command displays 802.1x configuration information.
Related commands: reset dot1x statistics, dot1x, dot1x retry, dot1x max-user,
dot1x port-control, dot1x port-method, dot1x timer.
Examples
# Display 802.1x configuration information.
<Sysname> display dot1x
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
EAD quick deploy is enabled
To Next Page
Loading...
Need help?
General
