H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-38
Description
Use the pim hello-option neighbor-tracking command to disable join suppression,
namely enable neighbor tracking, on the current interface.
Use the undo pim hello-option neighbor-tracking command to enable join
suppression.
By default, join suppression is enabled, namely neighbor tracking is disabled.
Related commands: hello-option neighbor-tracking.
Examples
# Disable join suppression on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim hello-option neighbor-tracking
4.1.40 pim hello-option override-interval
Syntax
pim hello-option override-interval interval
undo pim hello-option override-interval
View
Interface view
Parameters
interval: Prune override interval in milliseconds, with an effective range of 1 to 65,535.
Description
Use the pim hello-option override-interval command to configure the prune override
interval on the current interface.
Use the undo pim hello-option override-interval command to restore the system
default.
By default, the prune override interval is 2,500 milliseconds.
Related commands: pim hello-option lan-delay, hello-option lan-delay,
hello-option override-interval.
Examples
# Set the prune override interval to 2,000 milliseconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English