H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 2 HA Configuration Commands
2-2
2.1.2 ha slave-ignore-version-check
Syntax
ha slave-ignore-version-check
undo ha slave-ignore-version-check
View
System view
Parameters
None
Description
Use the ha slave-ignore-version-check command to ignore version check of the AMB
and SMB, meaning not to check the version of the AMB and SMB.
Use the undo ha slave-ignore-version-check command to enable version check of
the AMB and SMB.
By default, version check of the AMB and SMB is enabled.
Note that inconsistency of the software version of the AMB and SMB may result in
system failure when the system is running.
Examples
# Ignore version check of the AMB and SMB.
<Sysname> system-view
[Sysname] ha slave-ignore-version-check
2.1.3 slave auto-update config
Syntax
slave auto-update config
undo slave auto-update config
View
System view
Parameters
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English