H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-20
Commands fall into four command levels: visit, monitor, system, and manage, which
are described as follows:
z Visit level: Commands of this level are used to diagnose network and change the
language mode of user interface, such as the ping, tracert. The Telnet command
is also of this level. Commands of this level cannot be saved in configuration files.
z Monitor level: Commands of this level are used to maintain the system, to debug
service problems, and so on. The display and debugging command are of
monitor level. Commands of this level cannot be saved in configuration files.
z System level: Commands of this level are used to configure services. Commands
concerning routing and network layers are of system level. You can utilize network
services by using these commands.
z Manage level: Commands of this level are for the operation of the entire system
and the system supporting modules. Services are supported by these commands.
Commands concerning file system, file transfer protocol (FTP), trivial file transfer
protocol (TFTP), downloading using XModem, user management, and level
setting are of administration level.
Examples
# Configure commands of level 0 are available to the users logging in using the user
name of zbr.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] local-user zbr
[Sysname-luser-zbr] service-type telnet level 0
# To verify the above configuration, you can quit the system, log in again using the user
name of zbr, and then list the available commands, as listed in the following.
[Sysname] quit
<Sysname> ?
User view commands:
cluster Run cluster command
ping Ping function
quit Exit from current command view
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Undo a command or set to its default status
1.1.22 set authentication password
Syntax
set authentication password { cipher | simple } password

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English