H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 1 IGMP Snooping Configuration Commands
1-19
Description
Use the igmp-snooping query-interval command to configure the interval between
IGMP general queries.
Use the undo igmp-snooping query-interval command to restore the default setting.
By default, the IGMP general query interval is 60 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping querier, igmp-snooping max-response-time,
max-response-time.
Examples
# Set the interval between IGMP general queries to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping query-interval 20
1.1.21 igmp-snooping router-aging-time
Syntax
igmp-snooping router-aging-time interval
undo igmp-snooping router-aging-time
View
VLAN view
Parameters
interval: Router port aging time, in units of seconds. The effective range is 1 to 1,000.
Description
Use the igmp-snooping router-aging-time command to configure the aging time of
router ports in the current VLAN.
Use the undo igmp-snooping router-aging-time command to restore the default
setting.
By default, the aging time of router ports is 105 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: router-aging-time.
Examples
# Set the aging time of router ports to 100 seconds in VLAN 2.
<Sysname> system-view

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English