To Next Page

To Previous Page

Command Manual – NTP

H3C S7500E Series Ethernet Switches Chapter 1 NTP Configuration Commands

1-4

Table 1-2 Description on the fields of the display ntp-service status command

Field Description

Clock status Status of the system clock

Clock stratum Stratum level of the local clock

Reference clock ID

After the system clock is synchronized to a remote time

server or a local reference source, this field indicates the

address of the remote time server or the identifier of the

local clock source respectively:

z When the local clock has a stratum level of 1, the value

of this field is “LOCL”;

z When the stratum of the local clock has another value,

the value of this filed is the IP address of the local

clock.

Nominal frequency The nominal frequency of the local system hardware clock

Actual frequency The actual frequency of the local system hardware clock

Clock precision The precision of the system clock

Clock offset

The offset of the system clock relative to the reference

source

Root delay

The roundtrip delay from the local device to the primary

reference source

Root dispersion

The maximum error of the system clock relative to the

primary reference source

Peer dispersion

The maximum error of the system clock relative to the

reference source

Reference time Reference timestamp

1.1.3 display ntp-service trace

Syntax

display ntp-service trace

View

Any view

Parameters

None

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series