H3C S7500E Series Command Manual

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-4
View
Any view
Parameters
agg-id: ID of an existing service loop group.
Description
Use the display link-aggregation service-type command to display information
about the specified service loop groups.
If no aggregation group is specified, information about all service loop groups is
displayed.
Examples
# Display information about service loop group 1.
<Sysname> display link-aggregation service-type 1
Service-Loop Service Quote
Group ID Type Number
---------------------------------------------------------
1 tunnel 0
Table 1-2 Description on the fields of the display link-aggregation service-type
command
Field Description
Service-Loop Group ID Service loop group ID
Service Type Service type supported by the group
Quote Number
Reference count for the service loop group. Only after it
decreases to zero can you remove the group.
1.1.4 display link-aggregation summary
Syntax
display link-aggregation summary
View
Any view
Parameters
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English