H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-6
Field Description
Number of interfaces in this area
Number of interfaces attached to this
area
SPF algorithm executed 1 times SPF algorithm is executed 1 time
Number of LSA Number of LSAs
These LSAs’ checksum Sum Sum of all LSAs’ checksum
Number of Unknown LSA Number of unknown LSAs
3.1.6 display ospfv3 interface
Syntax
display ospfv3 interface [ interface-type interface-number | statistic ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
statistic: Displays the interface statistics.
Description
Use the display ospfv3 interface command to display OSPFv3 interface information.
Examples
# Display OSPFv3 interface information of VLAN-interface 200.
<Sysname >display ospfv3 interface Vlan-interface 200
Vlan-interface200 is up, line protocol is up
Interface ID 11665607
IPv6 Prefixes
FE80::20F:E2FF:FE00:5 (Link-Local Address)
2001:1::2
OSPFv3 Process (1), Area 0.0.0.1, Instance ID 0
Router ID: 1.1.1.1, Network Type: BROADCAST, Cost: 1
Transmit Delay is 1 sec, State: DR, Priority: 1
Designated Router (ID) 1.1.1.1
Interface Address: FE80::20F:E2FF:FE00:5
Backup Designated Router (ID): 2.2.2.2
Interface Address: FE80::20F:E2FF:FE00:2205
Timer interval configured, Hello: 10, Dead: 40, Wait: 40, Retransmit: 5

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English