H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-21
2.1.22 rip mib-binding
Syntax
rip mib-binding process-id
undo rip mib-binding
View
System view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the rip mib-binding command to bind MIB operations with a specified RIP
process.
Use the undo rip mib-binding command to restore the default.
By default, MIB operations are bound to the RIP process with the smallest process ID.
Examples
# Configure RIP 100 to accept SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding
2.1.23 rip output
Syntax
rip output
undo rip output
View
Interface view
Parameters
None
Description
Use the rip output command to enable the interface to send RIP messages.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English