H3C S7500E Series

Command Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 1 VLAN Configuration Commands
1-8
 Note:
z As the default VLAN, VLAN 1 cannot be created, or removed.
z You cannot create/remove reserved VLANs that are reserved for specific function
implementation.
z Dynamic VLANs cannot be removed using the undo vlan command.
z A VLAN configured with QoS policies cannot be removed.
z If an isolate-user-vlan or a secondary VLAN is associated to another VLAN using
the isolate-user-vlan command, the VLAN can not be removed unless the
association is removed.
z If a VLAN is configured as a remote mirroring VLAN, it cannot be removed using the
undo vlan command unless its mirroring VLAN configuration is removed first.
Related commands: display vlan.
Examples
# Enter VLAN 2 view.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2]
# Create VLAN 4 through VLAN 100.
<Sysname> system-view
[Sysname] vlan 4 to 100
Please wait............. Done.
1.2 Port-Based VLAN Configuration Commands
1.2.1 port
Syntax
port interface-list
undo port interface-list
View
VLAN interface view
Parameters
interface interface-list: Ethernet interface list, in the format of { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
means that you can specify up to 10 port ranges.