To Next Page

To Previous Page

Command Manual – Login

H3C S7500E Series Ethernet Switches

Chapter 1 Commands for Logging into an

Ethernet Switch

1-26

1.1.28 telnet ipv6

Syntax

telnet ipv6 remote-system [ -i interface-type interface-number ] [ port-number ]

View

User view

Parameters

remote-system: IPv6 address or host name of the remote system. An IPv6 address can

be up to 46 characters; a host name is a string of 1 to 20 characters.

-i interface-type interface-number: Specifies the outbound interface by interface type

and interface number. The outbound interface is required when the destination address

is a local link address.

port-number: TCP port number assigned to Telnet service on the remote system, in the

range 0 to 65535 and defaults to 23.

Description

Use the telnet ipv6 command to telnet to a remote device for remote management.

You can terminate a Telnet connection by pressing <Ctrl + K>.

Examples

# Telnet to the device with IPv6 address 3001::1.

<Sysname> telnet ipv6 3001::1

Trying 3001::1 ...

Press CTRL+K to abort

Connected to 3001::1 ...

**************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

**************************************************************************

1.1.29 telnet client source

Syntax

telnet client source { ip ip-address | interface interface-type interface-number }

undo telnet client source

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series