To Next Page

To Previous Page

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands

5-11

Examples

# Display IPv6 BGP path information.

<Sysname> display bgp ipv6 paths

Address Hash Refcount MED Path/Origin

0x5917098 1 1 0 i

0x59171D0 9 2 0 100i

Table 5-3 Description on the fields of the display bgp ipv6 paths command

Field Description

Address

Route destination address in local database, in dotted

hexadecimal notation

Hash Hash index

Refcount Count of routes that used the path

MED MED of the path

Path

AS_PATH attribute of the path, recording the ASs it has passed,

for avoiding routing loops

Origin attribute of the route, which can take on one of the following

values:

Indicates the route is interior to the AS.

Summary routes and routes defined using the network

command are considered IGP routes.

Indicates that a route is learned from the exterior

gateway protocol (EGP).

Origin

Short for INCOMPLETE. It indicates that the origin of a

route is unknown and the route is learned by other

means. BGP sets Origin attribute of routes learned from

other IGP protocols to INCOMPLETE.

5.1.13 display bgp ipv6 peer

Syntax

display bgp ipv6 peer [ ipv6-group-name log-info | ipv6-address { log-info | verbose }

| verbose ]

View

Any view

Parameters

ipv6-group-name: Name of an IPv6 peer group, a string of 1 to 47 characters.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series