Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Chapter 6 Multicast Routing and Forwarding
Configuration Commands
6-6
Table 6-4 Description on the fields of display multicast routing-table
Field Description
00001 Sequence number of the (S, G) entry
(172.168.0.2, 227.0.0.1) An (S, G) entry of the multicast forwarding table
Uptime
Length of time for which the (S, G) entry has
been up, in hours:minutes:seconds
Upstream interface
Upstream interface the (S, G) entry: multicast
packets should arrive at this interface
List of 2 downstream interfaces
Downstream interface list: these interfaces need
to forward multicast packets
6.1.4 display multicast routing-table static
Syntax
display multicast routing-table static [ config ] [ source-address { mask-length |
mask } ]
View
Any view
Parameters
config: Displays the configuration information of static routes.
source-address: Multicast source address.
mask: Mask of the multicast source address.
mask-length: Mask length of the multicast source address, in the range of 0 to 32.
Description
Use the display multicast routing-table static command to view the information of
multicast static routes.
Examples
# View all the multicast static routes.
<Sysname> display multicast routing-table static
Multicast Routing Table
Routes : 1
Mroute 10.10.0.0/16
Interafce = Vlan-interface1 RPF Neighbor = 10.10.0.254
Matched routing protocol = <none>, Route-policy = <none>
To Next Page
Loading...
Need help?
General
