Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 3 OSPF Configuration Commands
3-26
Field Description
ExStart
Under this state, the router decides on sequence numbers for DD
packets.
Exchange
Under this state, the router exchanges link state information with the
neighbor.
Loading Under this state, the router requests the neighbor for needed LSAs.
Full
Indicates LSDB synchronization has been accomplished between
neighbors.
Total Total number of neighbors under the same state
3.1.20 display ospf request-queue
Syntax
display ospf [ process-id ] request-queue [ interface-type interface-number ]
[ neighbor-id ]
View
Any view
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
interface-type interface-number: Interface type and number.
neighbor-id: Neighbor’s router ID.
Description
Use the display ospf request-queue command to display OSPF request queue
information.
If no OSPF process is specified, the OSPF request queue information of all OSPF
processes is displayed.
Examples
# Display OSPF request queue information.
<Sysname> display ospf request-queue
OSPF Process 1 with Router ID 1.1.1.1
OSPF Request List
The Router's Neighbor is Router ID 2.2.2.2 Address 10.1.1.2
Interface 10.1.1.1 Area 0.0.0.0
To Next Page
Loading...
Need help?
General
