EasyManuals Logo

H3C S7500E Series Command Manual

H3C S7500E Series
1565 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #793 background imageLoading...
Page #793 background image
Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-11
4.1.13 c-rp holdtime
Syntax
c-rp holdtime interval
undo c-rp holdtime
View
PIM view
Parameters
interval: C-RP timeout in seconds, with an effective range of 1 to 65,535.
Description
Use the c-rp holdtime command to configure the global C-RP timeout time, namely the
length of time the BSR waits before it must receive a C-RP-Adv message.
Use the undo c-rp holdtime command to restore the system default.
By default, the C-RP timeout time is 150 seconds.
Because a non-BSR router refreshes its C-RP timeout time through BSR bootstrap
messages, to prevent loss of BSR bootstrap messages, make sure that the C-RP
timeout time is not smaller than the interval at which the BSR sends bootstrap
messages. The recommended C-RP timeout setting is 2.5 times the bootstrap interval
or longer.
Related commands: c-rp, c-bsr interval.
Examples
# Set the global C-RP timeout time to 200 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-rp holdtime 200
4.1.14 crp-policy
Syntax
crp-policy acl-number
undo crp-policy
View
PIM view

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals