H3C S7500E Series

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-11
1.1.10 vrrp vrid timer advertise
Syntax
vrrp vrid virtual-router-id timer advertise adver-interval
undo vrrp vrid virtual-router-id timer advertise
View
Interface view
Parameters
virtual-router-id: VRRP standby group number, in the range 1 to 255.
adver-interval: Interval at which the master in the specified standby group sends VRRP
advertisements. It ranges from 1 to 255 seconds.
Description
Use the vrrp vrid timer advertise command to configure the Adver_Timer of the
specified standby group.
Use the undo vrrp vrid timer advertise command to restore the default.
By default the Adver_Timer is 1 second.
The Adver_Timer controls the interval at which the master sends VRRP packets.
Note that:
z Before executing the command, create a standby group on an interface and
configure the virtual IP address of the standby group.
z Routers in the same VRRP standby group must use the same Adver_Timer
setting.
Examples
# Set the master in standby group 1 to send VRRP advertisements at intervals of five
seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-Vlan-interface2] vrrp vrid 1 timer advertise 5
1.1.11 vrrp vrid track
Syntax
vrrp vrid virtual-router-id track interface interface-type interface-number [ reduced
priority-reduced ]
undo vrrp vrid virtual-router-id track [ interface interface-type interface-number ]