H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 6 Routing Policy Configuration Commands
6-15
Examples
# Define community-list 1, allowing routing information with community number 100 or
200 to pass. Then define a routing policy named test, whose node 10 is defined with an
if-match clause to reference the community-list for matching.
<Sysname> system-view
[Sysname] ip community-list 1 permit 100 200
[Sysname] route-policy test permit node 10
[Sysname-route-policy] if-match community 1
6.1.19 if-match cost
Syntax
if-match cost value
undo if-match cost
View
Routing policy view
Parameters
cost: Specifies the cost to match, ranging from 0 to 4294967295.
Description
Use the if-match cost command to specify a cost for matching against the cost of a
route.
Use the undo if-match cost command to remove the match criterion.
The match criterion is not configured by default.
This command is one of the if-match clauses of routing policy, used for matching routes
with the specified route cost.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match tag, route-policy, apply ip-address next-hop, apply cost, apply
local-preference, apply origin, apply tag.
Examples
# Create routing policy policy1 with node 10, matching mode as permit. Define an
if-match clause to permit routing information with a cost of 8.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match cost 8