Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Chapter 1 Information Center Configuration
Commands
1-2
If no channel is specified, information for all channels is displayed.
Examples
# Display information for channel 0.
<Sysname> display channel 0
channel number:0, channel name:console
MODU_ID NAME ENABLE LOG_LEVEL ENABLE TRAP_LEVEL ENABLE DEBUG_LEVEL
ffff0000 default Y warnings Y debugging Y debugging
Table 1-2 Description on the fields of the display channel command
Field Description
channel number A specified channel number, in the range 0 to 9.
channel name
A specified channel name, which varies with user’s
configuration. For more information, refer to the info-center
channel name command.
MODU_ID
The ID of the module to which the information permitted to pass
through the current channel belongs
NAME
The name of the module to which the information permitted to
pass through the current channel belongs
Default means all modules are allowed to output system
information, but the module type varies with devices.
ENABLE
Indicates whether to enable or disable the output of log
information, which could be Y or N.
LOG_LEVEL The severity of log information, refer to Table 1-4 for details.
ENABLE
Indicates whether to enable or disable the output of trap
information, which could be Y or N.
TRAP_LEVEL The severity of trap information, refer to Table 1-4 for details.
ENABLE
Indicates whether to enable or disable the output of debugging
information, which could be Y or N.
DEBUG_LEVEL
The severity of debugging information, refer to
Table 1-4 for
details.
The above information indicates to output log information with the severity from 0 to 4,
trap information with the severity from 0 to 7 and debugging information with the
severity from 0 to 7 to the console. The information source modules are all modules
(default).
1.1.2 display info-center
Syntax
display info-center
To Next Page
Loading...
Need help?
General
