Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches Chapter 2 RMON Configuration Commands
2-4
including event index, current event state, time the event was logged (the elapsed time
in seconds since system initialization/startup), and event description.
Examples
# Display the RMON log information for event entry 1.
<Sysname> display rmon eventlog 1
Event table 1 owned by user1 is VALID.
Generates eventLog 1.1 at 0days 00h:01m:39s.
Description: The 1.3.6.1.2.1.16.1.1.1.4.1 defined in alarm table 1,
less than(or =) 100 with alarm value 0. Alarm sample type is absolute.
Generates eventLog 1.2 at 0days 00h:02m:27s.
Description: The alarm formula defined in private alarm table 1,
less than(or =) 100 with alarm value 0. Alarm sample type is absolute.
Table 2-3 Description on the fields of the display rmon eventlog command
Field Description
Event table Event index
owned by Owner of the entry
VALID
Status of the entry identified by the index (VALID means
the entry is valid, and UNDERCREATION means
invalid. You can use the display rmon command to
view the invalid entry and with the display
current-configuration and display this commands
you cannot view the corresponding rmon commands.)
Generates eventLog at Time the log was created
Description Log description
2.1.4 display rmon history
Syntax
display rmon history [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Specifies a port by its type and number.
To Next Page
Loading...
Need help?
General
