H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-22
Destination: 300::/64 Protocol : Static
NextHop : 1::2 Preference: 60
Interface : Vlan1 Cost : 0
Refer to Table 1-9 for description about the above output.
1.1.15 display ipv6 routing-table ipv6-prefix
Syntax
display ipv6 routing-table ipv6-prefix ipv6-prefix-name [ verbose ]
View
Any view
Parameters
ipv6-prefix-name: Name of the IPv6 prefix list, in the range 1 to 19 characters.
verbose: Displays both active and inactive verbose routing information. Without this
keyword, only brief active routing information is displayed.
Description
Use the display ipv6 routing-table ipv6-prefix command to display routes permitted
by the IPv6 prefix list.
Examples
# Display brief active routing information permitted by the IPv6 prefix list test2.
<Sysname> display ipv6 routing-table ipv6-prefix test2
Routes Matched by Prefix list test2 :
Summary Count : 1
Destination: 100::/64 Protocol : Static
NextHop : :: Preference: 60
Interface : NULL0 Cost : 0
Refer to Table 1-9 for description about the above output.
1.1.16 display ipv6 routing-table protocol
Syntax
display ipv6 routing-table protocol protocol [ inactive | verbose ]
View
Any view