H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-22
Use the undo rip output command to disable the interface from sending RIP
messages.
Sending RIP messages is enabled on an interface by default.
Related commands: rip input.
Examples
# Disable VLAN-interface 10 from receiving RIP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] undo rip output
2.1.24 rip poison-reverse
Syntax
rip poison-reverse
undo rip poison-reverse
View
Interface view
Parameters
None
Description
Use the rip poison-reverse command to enable the poison reverse function.
Use the undo rip poison-reverse command to disable the poison reverse function.
By default, the poison reverse function is disabled.
Examples
# Enable the poison reverse function for RIP routing updates on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip poison-reverse
2.1.25 rip split-horizon
Syntax
rip split-horizon
undo rip split-horizon

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English